Fly Fishing Basics: Loading the Reel

By Andy Whitcomb

Feb 15, 2016

Because it is so unique, several aspects of fly fishing can be intimidating for a beginner or even someone just a little rusty.

Because it is so unique, several aspects of fly fishing can be intimidating for a beginner or even someone just a little rusty. Not only are the casting and fighting techniques different from all other methods but just the fishing basics of loading the reel with line can seem complicated. You need to know the three components (backing, fly line, leader), their sizes and lengths, and finally (gasp) the knots to join them.

Whoa! Come back here. Relax. I’m going to keep this simple: just two knots.

Fly fishing differs from all other fishing methods because it is the weight of the line that propels the lure in the cast rather than the weight of the lure being used to launch a length of fishing line. Because of the composition and diameter of the middle fly line piece, it would retain too much “memory” if the entire reel was filled just with fly line. That is, once it is coiled in the tight inner loops, it would want to stay in those tight inner loops. So that initial roll goes to a line called “backing.”

Backing is a heavy braid type line with no memory. It is tied to the reel with an arbor knot. This first knot is not much worse than tying your shoes. Just center it on the spool and tighten so it doesn’t spin. You’ll probably never see it again, unless should be lucky enough to cross paths with a tarpon.

After the backing, often sold in 100 yard lengths, comes the fly line. To connect, tie a nail knot. Take a deep breath. If I can do it, you can do it. Some instructions call for a “nail” but I use tiny straws from my kids’ empty juice boxes. This knot might take a couple of tries. But, then you can use that tying momentum and tie it again to connect the final part, the leader.

You could purchase a fly rod preloaded with line. Or, many sporting goods stores offer a reel-filling service. Recently, I loaded a friend’s reel using a fly line combo that matched the size of the fly rod and reel, in this case a 4/5 wt. This combo (100 yards of 20lb backing, 4WF fly line, and a 9 ft tapered leader) was reasonably priced and in the proper lengths to fully load the reel so all I had to do was tie two knots.

If you have more questions about fly fishing, we have more answers so check us out!

Andy Whitcomb
Andy Whitcomb
Andy is an outdoor writer (http://www.justkeepreeling.com/) and stressed-out Dad has contributed over 380 blogs to takemefishing.org since 2011. Born in Florida, but raised on banks of Oklahoma farm ponds, he now chases pike, smallmouth bass, and steelhead in Pennsylvania. After earning a B.S. in Zoology from OSU, he worked in fish hatcheries and as a fisheries research technician at OSU, Iowa State, and Michigan State.